Congratulations on being a new Bathmate Penis Pump owner! You’ve taken the first and most important step towards improving yourself.

HOW TO USE A BATHMATE PENIS PUMP FOR BEST RESULTS

Before getting started, it is highly recommended that you familiarize yourself with the safe and correct operation of this device. Improper operation/usage can result in less than optimum results and discomfort in some cases. For your convenience, we’ve prepared a handy user’s guide to help you along.

Important! Although the concept and function remain the same, different models contain slight variations, so how you use them will slightly differ. For safe use, make sure all parts are in place for your specific model.


CHECKLIST: HOW TO USE THE BATHMATE PUMP IN THE SHOWER OR BATHTUB

1. RELAX AND WARM-UP

Whether you’re using your Bathmate in the shower or in the tub, give yourself 5 minutes to warm up in the water. This will help stimulate circulation and enhance the effects of your device. This will also soften your testicles allowing them to be hung below the vacuum seal which will prevent discomfort or injury. To begin, fill your bathtub with warm water to whatever your comfort level is.



2. ATTACH ALL ACCESSORIES & CHECK YOUR BATHMATE

Make sure the release valve on your bathmate is closed. This will keep the water in your Bathmate needed to help you achieve an erection. If the valve is left open, the water will not stay in place. All three models have a valve control on the tip of the device. To make sure it’s closed, the tip must be upwards or downwards. If the valve tip is centered, the valve is still open. Also, make sure you add the comfort pad or any accessory that comes with your device.



3. FILL YOUR BATHMATE WITH WATER

For the device to work properly, it needs to be filled with water. For obvious reasons, the bathtub is the easiest place to use your Bathmate because you can place the device in the tub under the surface. If you opt to use it in the shower, you still need to fill the Bathmate with water in order to create a vacuum.


4. PLACE THE DEVICE ON TOP OF YOUR FLACCID PENIS

Once you’ve assumed a comfortable position in either the bathtub or shower, insert your flaccid penis into the pump’s chamber. Ensure that the chamber is facing downwards and there is minimal water spillage. Now, gently push the pump against your pubic bone and release the valve to place pressure on your penis. The increase in pressure will pull on your penis and give it a false erection.


5. ENSURE TO CREATE A TIGHT SEAL BETWEEN THE DEVICE AND YOUR SKIN

If you’ve followed step 4 correctly, the water-filled pump should be comfortably mounted on top of your penis. Throughout the procedure, try to move as little as possible – this helps maintain an airtight seal between the device and your skin.


6. ENSURE YOUR TESTICLES ARE OUTSIDE OF THE DEVICE IN A COMFORTABLE POSITION

Cup your testicles in your hands and make the required adjustments to make sure that your testicles are not hindered by the pump. This allows you to perform the procedure comfortably and will stop you from unintentionally placing pressure on your testicles.


7. USE SHOWER STRAP

If you are using your device in the shower, attach the shower strap before getting started. The strap gives you the freedom to use your hands for better control of the device and makes for a tighter fit. Make sure the strap is securely attached at all times to avoid dropping and damaging your device.


8. POINT YOUR BATHMATE SLIGHTLY UPWARDS

Now that you’re all set up and good to go, you’ll want to start by pointing your Bathmate slightly upwards. Hold the pump in both your hands gently but firmly. If you’re in the shower, lean against the wall or against the tub if you’re in the bath.


9. SET-UP THE VALVE SYSTEM

In order to create the vacuum, you need to set the valve to the open position by placing the tip of your Bathmate from the up or down position to the center position. This allows the water to be released. If the tip is not set to the open position, the water cannot be released. The Hydro, the Hydromax, and the Hydro Xtreme all have the valve tip on top of the device.


10. PUMP TO PRESSURIZE

After you set the valve to open, you can begin to pressurize your device. To do this begin pumping your Bathmate by moving it up and down slowly. And don’t over pump, as this can create too much pressure. Only use the minimum amount of pressure needed to achieve an erection.

If you have the Hydromax Xtreme, use the hand pump. Slowly pump until the bellows have depressed.


11. RE-PUMP TO MAINTAIN PRESSURE

Never over-pressurize the vacuum as it can injure your penis and cause severe pain. To avoid this, the Hydromax is designed to release pressure gradually For best results, the maximum time this device should be used is 15 minutes in 5 minute intervals.


12. ONCE FINISHED, RELEASE THE VALVE TO RELEASE THE VACUUM

To remove the Hydro or Hydromax, release the vacuum by pressing the valve inwards towards the pump. Make sure you press the whole valve and not just the latch. If you’re using the Hydromax Xtreme, turn the valve cap counterclockwise to relieve the pressure from your device.


13. MAKE A BREAK AND MASSAGE PENIS

Every 5 minutes, take a short break and gently massage your penis to relieve tension. If it’s your first time using the Hydro pump, start gradually and slowly ease into the routine – this means doing intervals less than 5 minutes.

While you may want to see quick results, don’t go overboard and try to hit the max time on your first use. Just like any exercise, consistency and patience are key. Overexerting yourself will only lead to injury.


14. REPEAT EVERY 5 MINUTES, WITH A MAXIMUM OF 15 MINUTES PER SESSION

Break up your sessions into three intervals that each last for 5 minutes. During each interval, you’ll want to inflate and deflate the pump for 5 minutes. This ensures that you won’t run the risk of accidentally overstraining yourself.

While you may be tempted to push your body to its limits to achieve results faster, this approach is not advisable. Overstretching your penis can cause injury and significant discomfort. Remember to keep your expectations in check and don’t get disappointed if you don’t see results after just a few days.


DOES IT INCREASE BOTH LENGTH AND GIRTH?

Penis pumps have two major advantages over jelqing. Firstly, the entire process is fully-automated which makes penis enlargement easier and more convenient.

Secondly, the pump applies force to your penis in all directions. Forwards and sideways, upwards and downwards, stretching your penis tissue in several directions thus allowing you to simultaneously work out different muscle groups.

What all of this means is that the Bathmate penis pump does indeed increase both your length and girth. Even better, it does all of this at the same time without you having to do anything else.

Penis pumps like that from Bathmate work by creating a vacuum around the penis which creates a false erection. Thus stretching the penis in a variety of directions and encouraging the formation of microtears.

Microtears occur when muscle tissues i.e. those on your penis, are worked. In response, the body increases the flow of blood and nutrients to the penis in order to stimulate growth and recovery. Thus enabling the penis to literally grow in both length and girth.

This concept has been used for centuries by athletes who lift weights in order to increase their muscle mass and size.

ital that you remain consistent and disciplined in your efforts to improve yourself.